All CQ Series products feature multiple pairs of power outputs, Power Pods(TM), which are turned on every 2 seconds. Equipment to be powered plugs directly into the CQ device. All CQ models have the ability to transmit a sequence command to another CQ unit or to receive a remote sequence command from another CQ unit or from an RC5 Remote Control/Monitor accessory or any contact closure. In this way, any CQ Series product can be a master or slave unit. A power sequencing system can be built from several CQ Series products which can be selected depending on the specific requirements of a particular installation: number and location of circuits, current (amps) requirement of circuit, number of control locations, number of sequence events. Select only the specific CQ Series products to meet a specific requirement. The time delay between sequence events is 2 seconds, controlled by the CQ Series software. The order in which powered equipment is turned on depends on which Pod that equipment is plugged into and where that Pod is located relative to the entire CQ system.
- Three position switch on the front of the chassis
- Switch is active only if there is no control cable on the Sequence Signal Input connector
- Switch allows the unit to sequence up or sequence down